Error codes Cruise 2.0 / 4.0

Error Cause What to do
E02 Stator over-temperature (motor overheating) Motor can be used again after a short wait (about 10 minutes). Contact Torqeedo Service
E05 Motor / propeller blocked Switch main switch to ”OFF” position, then remove blockage and turn propeller one revolution by hand. Reconnect motor cable
E06 Voltage in the motor too low Low battery charging status. Motor can potentially be used again slowly from the stop position.
E07 Motor overcurrent Continue at low output
E08 Circuit board overheating Motor can be used again after a short wait (about 10 minutes). Contact Torqeedo Service.
E21 Tiller calibration defective • Re-calibrate: Press “cal” button for 10 seconds
• The display shows “cal up”: Press tiller forward to full gas then press the “cal” button
• The display shows “cal stp”: Return tiller to central postion then press the “cal” button
• The display shows “cal dn”: Press tiller backward to full gas then press the “cal” button